Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×

Thread Tools Search this Thread Display Modes
Old 04-29-2019, 03:05 PM   #1
Junior Member
lensmanicu's Avatar
Join Date: Apr 2019
Posts: 20
Question Additional Slideout question

When looking at each end of slideout the front end looks level while the rear end looks to be slopping slightly down giving the impression it might be slightly twisted. From the inside of camper the gasket at the rear is fitting snug until the last foot or so. Further when you lift the rug apron the particle board at the bottom under the coach is higher then the living room floor while the other end appears to be level.... So if I was to put a six tun jack under the main support beam the one with gear track on it and lift slightly do you think that will pull every thing into alignment so I can tighten the bolt at the end. With out damaging anything. Or do you have another suggestion. Please advise.
2004 Fleetwood Prowler Lynx Ultra Light
Been RVing for 15 years
lensmanicu is offline   Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3

All times are GMT -5. The time now is 05:30 AM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.