Mor-Ryde Pin Box

[sprehoda]

I have the Mor-Ryde rubber pin box and more weight on the front axles versus the rears.

I went to a dealer to have it lowered one notch and was told that there were not enough holes to have five bolts on each side.

Could this be right that Mor-Ryde would design a pin box that could not be adjusted down.

Or would four bolts on each side be enough?

Steve Prehoda

 

[5thwheeler]

Boonville RV

Contact Kara at 855-698-3332 Booneville RV (Dale Fenton's new venture)
She knows all the answers re your pin box

 

[Porkchop-THOR]

Kara may very well know the answer to the question, however Dale had Trail Air not Mor Ride

Bill

 

[wingnut60]

My Morryde pin box has only 4 bolts in it--has held up for 7 years with 17k weight and 4200 pin weight...grade 8 bolts/washers/nuts.
Joe

 

[sprehoda]

Our pin box has 5 bolts and is rated 23,000#.

Our rig is 22,000# a little over weight.

I need expert advice that 4 bolts will be OK.

Steve Prehoda

 

[wingnut60]

Then you need to call Morryde...
Joe