Reply
 
Thread Tools Search this Thread Display Modes
 
Old 01-29-2020, 12:35 PM   #1
MTK46
Senior Member
 
Join Date: Dec 2018
Location: Desert Hot Springs Ca.
Posts: 201
Changing out TV

Looking to replace our 2011 TV that works just fine with a smart TV. There is very little room to get to the mounting screws that attached it to the powered lift.
Has anyone upgraded their old TV.
Our old one is a Sony Bravia 40"
New 43" will fit just fine. I just can't figure out how to get the old one out.
__________________

__________________
Mike & Trish Romans 10:9
2011 Mobile Suites 36RSSB3 #5556
2017 bought 10/14/19 F-350 CC 6.7 diesel dully
MTK46 is offline   Reply With Quote
Old 01-31-2020, 02:12 PM   #2
woodman
Junior Member
 
Join Date: May 2015
Posts: 4
use # 8 Robertson square drive screw driver to remove mounting screws.
__________________

woodman is offline   Reply With Quote
Old 01-31-2020, 07:58 PM   #3
MTK46
Senior Member
 
Join Date: Dec 2018
Location: Desert Hot Springs Ca.
Posts: 201
That doesn't help me figure out how to get to them.bu
__________________
Mike & Trish Romans 10:9
2011 Mobile Suites 36RSSB3 #5556
2017 bought 10/14/19 F-350 CC 6.7 diesel dully
MTK46 is offline   Reply With Quote
Old 02-01-2020, 06:12 AM   #4
Notanlines
Senior Member
 
Join Date: Oct 2017
Location: Germantown, Tennessee
Posts: 400
Mike usually the TV in the main living area is removed by lifting from both ends (usually with a lot of force) and then pulling out again on the bottom and it comes away from the wall.
__________________
Jim and DW 48 years Brenda
2017 38rssa
2019 F450, ruby red
Harley Road King & sidecar
Notanlines is offline   Reply With Quote
Old 02-01-2020, 11:06 AM   #5
Cummins12V98
Senior Member
 
Join Date: Feb 2013
Location: on the road
Posts: 727
OP's TV drops down into the cabinet I believe?
__________________
2015 RAM LongHorn Dually Air ride Aisin 4:10's

2016 MS 39TKSB3 "Highly Elited"
Cummins12V98 is offline   Reply With Quote
Old 02-01-2020, 11:13 AM   #6
MTK46
Senior Member
 
Join Date: Dec 2018
Location: Desert Hot Springs Ca.
Posts: 201
Yes mine is behind the fireplace on a motorized lift.
It's at the end of the kitchen slide.
__________________
Mike & Trish Romans 10:9
2011 Mobile Suites 36RSSB3 #5556
2017 bought 10/14/19 F-350 CC 6.7 diesel dully
MTK46 is offline   Reply With Quote
Old 02-01-2020, 11:42 AM   #7
OCB
Member
 
Join Date: Jun 2018
Posts: 40
This is how my Oct 2015 built RV, TV is mounted. I haven't had my removed on this RV but I would loosen the 2 screws, each side and lift it up and out. Then detach the wiring. Last step remove the mounting frame from the TV.
I had a 2010 Montana that had a lift problem that required the TV removal that was similar to this attachment.


(I love my cell phone camera for working tight spots. Better than a mirror when trying to explain something to your helper. Better than a magnifying glass to see the detail.)
Clay MS 38PS3
OCB is offline   Reply With Quote
Old 02-01-2020, 11:47 AM   #8
OCB
Member
 
Join Date: Jun 2018
Posts: 40
TV mounting bracket (2).jpg
Problem with the previous post loading the picture. It seem I can login, type the message and then it will tell me I'm not logged in. Top right of the page says I'm logged in. Is there time limit?
OCB is offline   Reply With Quote
Old 02-01-2020, 11:54 AM   #9
MTK46
Senior Member
 
Join Date: Dec 2018
Location: Desert Hot Springs Ca.
Posts: 201
I didn't think to look at the lift. I was just looking at the TV mount area. I'll take a new look.
__________________
Mike & Trish Romans 10:9
2011 Mobile Suites 36RSSB3 #5556
2017 bought 10/14/19 F-350 CC 6.7 diesel dully
MTK46 is offline   Reply With Quote
Old 02-01-2020, 07:55 PM   #10
Druidcat1115
Junior Member
 
Join Date: Jan 2020
Location: Gainesboro, Tn
Posts: 11
mine has a different brand of lift but if you look over the tv from the top you can see the bolts that hold the tv mount to the lift pedestal. Remove the tv mount from the lift pedestal then remove the mount from the tv. put the old mount on the new tv then hang the mount back on the lift pedestal.
Druidcat1115 is offline   Reply With Quote
Old 02-03-2020, 04:38 PM   #11
D5354t
Junior Member
 
Join Date: Sep 2019
Posts: 1
TV replacement

Quote:
Originally Posted by MTK46 View Post
Looking to replace our 2011 TV that works just fine with a smart TV. There is very little room to get to the mounting screws that attached it to the powered lift.
Has anyone upgraded their old TV.
Our old one is a Sony Bravia 40"
New 43" will fit just fine. I just can't figure out how to get the old one out.
I replaced mine in a DRV with the elevator. What I did was I retracted the TV about half way down so I could see behind it from the top. There were 3 screws on top of the mount that I was able to take out and then the TV just picked up off.
D5354t is offline   Reply With Quote
Old 02-04-2020, 11:42 AM   #12
Cummins12V98
Senior Member
 
Join Date: Feb 2013
Location: on the road
Posts: 727
^^^^^ Sounds like a good answer and welcome to the Forum! ^^^^^
__________________

__________________
2015 RAM LongHorn Dually Air ride Aisin 4:10's

2016 MS 39TKSB3 "Highly Elited"
Cummins12V98 is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3

All times are GMT -5. The time now is 10:57 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
×