|
Cummins - for the life of me, I can't find where I said "I" removed them. I find where I said I took them to the hydraulic shop. But I'm tired, and not going to re-read those posts a 3rd time. So, I'll stand corrected. I didn't remove them, but had them removed. The place that did it, used a forklift with a pin receiver mounted to the forks to raise the front of the DRV high enough to get out from below, whatever they were taking out -the sleeve and hydraulic cylinder. I'd front of the DRV was raised, I'd say, about 4-1/2 feet
|