Thread: Refer
View Single Post
Old 08-07-2007, 05:20 PM   #5
rotaxman
Senior Member
 
Join Date: Jul 2005
Location: Liberty Mo (Suburb of Kcmo)
Posts: 559
Refer

upon further investagation it appeared that one of the fans was not spinning as fast as the other. I purchased a new fan at a local computer place and installed it.

The wiring was a nightmare DT made a big deal out of nothing poor worksmanship as usual. I cleaned up the wiring and started her up yesterday afternoon this morning the temp was 34 degrees so I guess things are ok time will tell.

It amazes me that there isn't a 36TK3 burning up everyday. The installation design is common DT very very poor. The refer should have been where the pantry is and the pantry where the refer is. The flue just vents out into the top of the refer compartment which is where it stagnates to some point hence the fans to help move the hot air out. But being the top vent is a few inches below the top of the compartment it gets very warm in there. I constructed a baffel from alum that directs the hot air toward the vent and outside of the compartment. Something that should have been done at DT

Anyway hope that my problems are behind me.

Thanks for all of the advise fellas I appericate the help

As always good camping

Joyce and Jerry
__________________
Jerry Sharp
Joyce McAlpin
Two Lives One Dream
2000 F 450 V10
5.38 gears trailer special
Automatic 4R100
20000# Reese Hitch
Trail Air Suspension and Pin Box with Tri Glide
Honda 4500 ex
Hughes Internet
Garmin 2720 talking GPS
Pressure Pro
Junk frame 2009 38TKSB3 #4750
rotaxman is offline   Reply With Quote