I ran into a unique situation where I had to pull over the rool boll of a tree with my tv after unhooking. I had to raise the front of the MS quite a bit so the bed wouldn't hit the underside. Then it would not lower enough to level so (don't try this at home) I supported the MS with my stabilizer tripod and raised the legs and pulled the blocks out. Had to do it twice and it held but I was sure nervous. When I hooked back up I was able to get the tv in a position to put blocks to support the pin in the bed then lift the legs to put blocks under them to get the height to the hitch.
__________________
Happy Trails To You
Tom & Cheryl Brockman S.O.I.T.C. Charter Member
2015 39DBRS3, Truma water heater, 2inch lift, custom paint
2011 RAM Cummins 3500 Dually
|