5thWheelForums.com - View Single Post - Ford TBC & Carlisle HBA-CAM?

golf_bears · 10-19-2011, 02:29 PM

I haven’t been on the road yet with the HBA-CAM active. I have been using my Hensley break controller which has been working fine. Last spring, in Las Vegas, the Hensley BC gave me a few problems so was traveling short distances without any trailer breaks until my Hensley controller problem was resolved. That is when I decided I would install the HBA-CAM module and get the Ford TBC working properly. Now I have breaks working off of both break controllers. Not sure which one I will use as a back up but I have no intentions of being on the road with no trailer breaks again, too scary.

So those of you using the HBA-CAM, what are your settings?

USA in a Chevrolet, thanks for giving me your settings. Will probably be the same for the Ford? I think your assessment of Carney Bill’s problem may be correct.

10-19-2011, 02:29 PM	#5
golf_bears Senior Member Join Date: May 2007 Location: West Bend, Wisconsin Posts: 397	I haven’t been on the road yet with the HBA-CAM active. I have been using my Hensley break controller which has been working fine. Last spring, in Las Vegas, the Hensley BC gave me a few problems so was traveling short distances without any trailer breaks until my Hensley controller problem was resolved. That is when I decided I would install the HBA-CAM module and get the Ford TBC working properly. Now I have breaks working off of both break controllers. Not sure which one I will use as a back up but I have no intentions of being on the road with no trailer breaks again, too scary. So those of you using the HBA-CAM, what are your settings? USA in a Chevrolet, thanks for giving me your settings. Will probably be the same for the Ford? I think your assessment of Carney Bill’s problem may be correct.