5thWheelForums.com - View Single Post

RickandJanice · 08-21-2010, 03:54 PM

Just finished repairing our wire support under the door side slide. It was broken in the middle of the support. I used the hinge method that is commonly used when these break at the attach points but since this was in the middle, I attached the hinge in reverse so it will not close completely. This prevents pinching the wires or over bending them.

08-21-2010, 03:54 PM	#12
RickandJanice Senior Member Join Date: Jul 2009 Posts: 119	Just finished repairing our wire support under the door side slide. It was broken in the middle of the support. I used the hinge method that is commonly used when these break at the attach points but since this was in the middle, I attached the hinge in reverse so it will not close completely. This prevents pinching the wires or over bending them. __________________ Rick and Janice Binns 2006 MS 32TK3, Mor/Ryde Pin Box and I.S., Auto Level-Up 2012 Ford F450 6.7 L Diesel, air bags and 25K Reese Signature hitch (factory installed)