Update
so , its just a cheep system from princess auto which sells lower end tools & what not.
they are aftermarket hydraulics the previous owner had installed himself.
was just out messing around with them & since i parked it last fall , now the solenoid just "clicks" & nothing happens. i went & replaced the solenoid & still just clicks. i can also see that when i press the "retract" direction the little LED on the directional switch comes on & stays on for the duration i hold it in. the "extend" directional switch , i have to press it a few times for the LED to light up....not sure what the LED indicates.
totally stumped here.....if i pull the pump & motor off , hook it directly to a 12 source , it should theoretically run if theirs nothing wrong with the motor right ?
a
thanks guys for the help & suggestions so far
|