5thWheelForums.com - View Single Post

missourijan · 08-17-2007, 12:40 PM

There is an area about 18 inches long next to the black/grey tank outlet pipe that has nothing securing the bellypan material to the frame/beam. It has a gap of about 2 inches. Apparently it's been that way for awhile, we can see that the insulation is a little dirty. DH doesnt really want to put screws into the frame, but is that the only solution? I was thinking of some hard plastic "thing" that would hold the bellypan material snug up against the beam. Maybe there was a piece of rubber from the factory like under the stairs, but those are a joke. Any suggestions?

08-17-2007, 12:40 PM	#1
missourijan Senior Member Join Date: May 2006 Location: Tucson, AZ Posts: 131	Info about bellypan material There is an area about 18 inches long next to the black/grey tank outlet pipe that has nothing securing the bellypan material to the frame/beam. It has a gap of about 2 inches. Apparently it's been that way for awhile, we can see that the insulation is a little dirty. DH doesnt really want to put screws into the frame, but is that the only solution? I was thinking of some hard plastic "thing" that would hold the bellypan material snug up against the beam. Maybe there was a piece of rubber from the factory like under the stairs, but those are a joke. Any suggestions? __________________ Jan & Thomas 2012 Mobile Suite #5942 2012 Ford F350 Super duty "We used to work, now we workamp"