View Single Post
Old 01-19-2009, 09:18 PM   #9
ponch
Senior Member
 
Join Date: Nov 2005
Location: Springfield, Il.
Posts: 655
Send a message via AIM to ponch Send a message via MSN to ponch
On the front right of the coach is a plastic tube looking affair that sticks up. On top there is an opening that is about 3/4 of an inch tall with bars that run vertical all the way around it and then it's solid all the way down to the roof.
This is the wind sensor.

If you unscrew it from the top of the roof you will find nothing more than a wire, that comes out of an opening, that plugs into the bottom of the unit that you just unscrewed form the top of the roof. There is nothing else in the hole. No tube, nothing.

That wire runs straight down to the master box that is attached to the fornt of the basement.

If you have a beeping sound coming from the box,when you have the wind sensor enabled, then you have one of three problems present. Either the temp is below 31 degrees, I believe that is the correct temperature, or the wire that I just described does not have power down to the base unit or the mother board is bad.

Hope that helps.
__________________
Ponch
S.O.I.T.C. Central Division
2007.5 3500 HD GMC dually
Mobile Suites 2005 36CK3 #2307 w/ auto levelers/ phase 2
Air Safe Hitch
HD TV in the basement and living room and bedroom
HD MOTO SAT Auto Ant on roof
pressure pro
ponch is offline   Reply With Quote