Quote:
Originally Posted by Larry drv 7*3
Guess you may want to pull that bolt holding square tube position. May need to be clocked to different position to align both ends of slide
Just a mechanical / engineering guess
|
Larry, I'm not really following you
. When my slide is all the way out both corners at the bottom on the inside are showing a gap. I adjusted the bolts on the hydro ram to make it 'longer' thus pushing the bottom of the slide out farther. This took up about half the gap I had and will adjust it further, just haven't gotten around to it yet. Other then that I think the slide is aligned OK top and sides. It bothers me though that bringing the slide out there is a noise about a foot out but pulling it back in its smooth all the way in.