|
Being difficult depends on the furnace location. Yes Suburban has a new board out and so does Dinosaur with the six pin plug set up. I bought the dinosaur for $96 delivered. Now if you have the large outside panel on the outside which the intake air intake and exhaust pipe attach to you can remove it and from there you will see the board to the left attached by a stamped metal bracket which is attached to the motor by two screws. Further if you set is similar to mine you will need to disconnect the gas line (13/16 open end wrench) and move out of the way. There is also a clamp which holds the line in place which needs to be unscrewed. Ofset screw drive will do the trick. From there you may or may not have to cut 4 wires which attach to plugs which connect to the board. I pulled the furnace but in retrospect probably could have left it in place maybe. If you need anything else let me know.
|