slide 'BANG' won't go out!

[oldbird]

I have no idea except for the slide is out of alignment. The bottom is not going out all the way but I made an adjustment on the hydraulic ram to help with that. I can't see why that would cause teeth to brake off the gear pack?

[Larry drv 7*3]

Guess you may want to pull that bolt holding square tube position. May need to be clocked to different position to align both ends of slide
Just a mechanical / engineering guess

[oldbird]

Originally Posted by Larry drv 7*3

Guess you may want to pull that bolt holding square tube position. May need to be clocked to different position to align both ends of slide
Just a mechanical / engineering guess

Larry, I'm not really following you . When my slide is all the way out both corners at the bottom on the inside are showing a gap. I adjusted the bolts on the hydro ram to make it 'longer' thus pushing the bottom of the slide out farther. This took up about half the gap I had and will adjust it further, just haven't gotten around to it yet. Other then that I think the slide is aligned OK top and sides. It bothers me though that bringing the slide out there is a noise about a foot out but pulling it back in its smooth all the way in.