Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
 
 


Reply
 
Thread Tools Search this Thread Display Modes
 
Old 09-19-2010, 07:26 PM   #1
jas24
Member
 
Join Date: Aug 2009
Location: way down here, FL
Posts: 70
ladder

Hi guys,

If you haven't done so, you might want to check the screws where they fasten to roof and the ladder fastens to the 2 brackets on the roof. Makes it a lot stronger when replaced with bigger S/S screws.


Jack
__________________

__________________
Jack

06 F-350 Lariat 4x4 V-10 CC SRW LB
06 Mobile Suites 36CK3
jas24 is offline   Reply With Quote
Old 09-19-2010, 10:45 PM   #2
RonS
Senior Member
 
Join Date: Oct 2006
Location: New Lisbon, Wisconsin
Posts: 317
Jack - What size screws did you put in??
__________________

__________________
06 MS 36TK3 #2473 w/(Phase II)side to side levelers, Trailair pin box w/Tri-Glide plate.
2011 Dodge 3500 CC 4x4 Diesel DRW Power Tuner guages etc
RonS is offline   Reply With Quote
Old 09-20-2010, 08:43 AM   #3
jas24
Member
 
Join Date: Aug 2009
Location: way down here, FL
Posts: 70
ladder

Ron,

The screws that fasten brackets to the roof, used 3" long and around 1/4".
Need to drill brackets out a little w/ 13/64 bit.
Screws to fasten ladder to brackets were slightly larger than factory put in, longer than factory used.
All my screws were hex head Stainless steel.
Hope this helps
__________________
Jack

06 F-350 Lariat 4x4 V-10 CC SRW LB
06 Mobile Suites 36CK3
jas24 is offline   Reply With Quote
Old 09-20-2010, 08:07 PM   #4
BobW
Senior Member
 
Join Date: May 2006
Location: Welches Oregon
Posts: 523
You don't need 3" screws to go into 3/4 inch waffler board. I drilled out the bracket to 1/4 inch and put 1/4 inch screws in. Fill the old holes with silicon. By the way, this ladder is junk. We had two bikes on it and the ladder broke and the bikes hit the ground. DT replaced the ladder. Still junk.
__________________
Bob and Kate Weigant
Welches Oregon
Elite 2006 36TK3
2007 M2 Freightliner
2005 Wrangler
In a land of the blind, the one eyed guy is king.
BobW is offline   Reply With Quote
Old 09-22-2010, 10:31 AM   #5
RonS
Senior Member
 
Join Date: Oct 2006
Location: New Lisbon, Wisconsin
Posts: 317
BobW - So how long were the screws that you used for the base? What did you use as replaceent to hold ladder to base? I agree the ladder is junk, but still use it.

Thanks Ron
__________________
06 MS 36TK3 #2473 w/(Phase II)side to side levelers, Trailair pin box w/Tri-Glide plate.
2011 Dodge 3500 CC 4x4 Diesel DRW Power Tuner guages etc
RonS is offline   Reply With Quote
Old 09-22-2010, 10:36 AM   #6
BobW
Senior Member
 
Join Date: May 2006
Location: Welches Oregon
Posts: 523
Quote:
Originally Posted by RonS
BobW - So how long were the screws that you used for the base? What did you use as replacement to hold ladder to base? I agree the ladder is junk, but still use it.

Thanks Ron
Considering the roof plywood is only 3/4", I used 1.5 inch lag screws. The screws are 1/4 inch. I had to drill out the bracket to accept the screw. I got a piece of 1/4 inch plate about 4x4 inches and placed it under the bracket. Screwed it to the roof and screwed to bracket to it. Still I don't use the ladder.
__________________
Bob and Kate Weigant
Welches Oregon
Elite 2006 36TK3
2007 M2 Freightliner
2005 Wrangler
In a land of the blind, the one eyed guy is king.
BobW is offline   Reply With Quote
Old 09-27-2010, 12:56 AM   #7
Jack in Alaska
Senior Member
 
Join Date: Jun 2005
Location: Anchorage & Ninilchik, Alaska
Posts: 291
You are correct that the ladder is not of the best quality but it is sufficient for the occasional use that it gets of occasionally climbing up and down from the roof. It is made to climb up and down on the roof and that is it.
It is not a bike rack or chair hanger or flag pole holder. Not designed for that.
A bike hanging on it going down the road continuously wiggles back and forth, up & down and in and out. A flag pole does the same thing as well as chairs. That ladder just can not take that kind of abuse. Buy a bike rack that fastens to the trailer frame or a hitch on the trailer. Those are plenty strong for that use.

Now that being said..........I wish that DRV would use a little more care when installing the ladder.
__________________
2012 Jayco 40FER Bungalow TT
2004.5 Dodge 3500 DRW 4x4 Quadcab CTD 325/600 6 spd 3.73 HiJacker Hitch;Access bed cover; Prodigy; PacBrake; DZ boards;air horns;Westach combo gauge;Sirius;Smarty Jr, Lite Force road lites
Yamaha iSEB 3000 genset

Start Out Each Day Real Easy.......Then Taper Off
Jack in Alaska is offline   Reply With Quote
Old 09-27-2010, 05:16 AM   #8
jas24
Member
 
Join Date: Aug 2009
Location: way down here, FL
Posts: 70
ladder

I have the hitch for a DRV, the 2 brackets that get welded to the frame and the bike rack for sale if anyone is interested......
__________________

__________________
Jack

06 F-350 Lariat 4x4 V-10 CC SRW LB
06 Mobile Suites 36CK3
jas24 is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3

All times are GMT -5. The time now is 05:15 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
×