Quote:
|
Originally Posted by keithandpenne
Bob, None or our rollers pass over the vent grills. Also, I did not put down any underlayment. I just layed it over the plywood flooring, after I pulled at least 1,000,011 staples. I did not take all of the vinyl out but would if I were doing it again to help reduce weight gain. I see no reason why there should be any problem with the rollers and this flooring, I did however glue the joints under the area where the slide rolls on it. You can get to the rollers from outside under the slide by pulling down the rubber seal. I used a scrap of the flooring to shim under the roller attached to the floor.
|
We had some problems with this flooring. If you get it wet, it will swell up at the seems. Ours did. I thought if you did put a foam insulator under the flooring, it would buckle and brake from the weight of the rollers. Your unit must be newer than mine, because ours do roll over the vents. In fact the vents are bent from this action.