5thWheelForums.com - View Single Post

Motor31 · 11-23-2008, 10:05 AM

Go to the hydraulic manifold and check the knurled knobs. Make sure they are all screwed as far as they can go to the left. If they are then you might want to just screw them in and then out to see if that frees up the valve inside of them. Don't forget the one for the back legs. On ours that is all the way back at the rear street side leg.

You might also tap the manifold gently with a non marring hammer while operating the legs and slides.

Have you been having any leakage from either fittings or at the manifold?

11-23-2008, 10:05 AM	#2
Motor31 Senior Member Join Date: May 2005 Posts: 2,130	Go to the hydraulic manifold and check the knurled knobs. Make sure they are all screwed as far as they can go to the left. If they are then you might want to just screw them in and then out to see if that frees up the valve inside of them. Don't forget the one for the back legs. On ours that is all the way back at the rear street side leg. You might also tap the manifold gently with a non marring hammer while operating the legs and slides. Have you been having any leakage from either fittings or at the manifold? __________________ Mike Nancy and the fuzzies Fulltiming since June 2004 Volvo 660 MH tow vehicle 2005 MS 38RL 2007 Saturn Ion "toad" 2010 Gold Wing "piggyback"