[frostth]

I have, I think the older version of the power awning and am concerned about it retracting under high wind conditions. I have never seen it do this automatically under what I thought were windy conditions. I have read all the other posts on this subject and didn't see any specific detail on how to set the wind sensor.
In looking at my control box in my basement there is a circuit board with no settings other than a dip switch with about 5 or 6 positions with the ability to set them either up or down.
Is this where the sensitivity is set for the wind sensor? If so, does anyone have the detail on how these switches should be set? Also, I have two connectors at the control box that are not connected to anything. Is this possibly for a more intelligent controller?
My awning operates fine manually and it appears the wind sensor is connected properly because if you disconnect the wire the control box starts beeping.
Any help on details would be appreciated.