Not sure if ours is the exact same brand, but I just fixed it for no heat. Once out, the top comes off with screws around the back and sides. It had a wire that broke off the terminal to the heater element. I soldered it back and good as new.
If you can carry out some tests with a multimeter and you don't find any broken wires, do an ohms check (with unit unpluged) through the heat element to see if it has an open, it should have continuity. If it is open, then just need a new element. If the element is OK, then see if you get voltage to the element when selected on to check the switch and thermostat. Will have to plug in for this.
Bill
|