Thread: wiring diagram
View Single Post
Old 08-08-2008, 12:57 PM   #13
BobW
Senior Member
 
Join Date: May 2006
Location: Welches Oregon
Posts: 523
Quote:
Originally Posted by shergry
If you are over length of 6 feet that can also cause blowing from under gauge wire.
Under gauge wire or over length wire can cause of the inverter fuse, if the load is too much.
.
I'm not so sure about that. A wire under rated should not blow a fuse, it will burn the wire, not blow the fuse. A blown fuse is caused from excess amperage. If, let's say, the wire is smaller than the fuse, the wire will fail first causing melting of the insulation and burning. Think of what a fuse is. It's a link that is smaller that the circuit it occupies. Also the longer the wire is changes it's resistance. This will also heat up the wire and not blow a fuse. This is a big problem in homes, where a person adds a larger breaker to the fuse panel. Of corse the breaker won't go off. But the wiring will be heated up and acts as the weak link.
__________________
Bob and Kate Weigant
Welches Oregon
Elite 2006 36TK3
2007 M2 Freightliner
2005 Wrangler
In a land of the blind, the one eyed guy is king.
BobW is offline   Reply With Quote