View Single Post
Old 12-30-2016, 06:57 PM   #3
Suite Sweets
Senior Member
 
Join Date: Dec 2016
Posts: 107
Six years and no parts. That's a kick in the head. Contributing without having seen the 'sprung', could you support 2 corners on the level, and then put weight on the other two (diagonal) corners, to draw the door plumb ?
Years ago, I had the same experience. The door was made of two flat panels that were screwed together. There was 3/4" of space between the two panels, filled with insulation. I unscrewed the inside panel from the outside panel, and placed a 1/2" x 1/2" angle therein, and machine screwed it to the front panel of the door (heads showed from the front). Hope this does you some good.
Suite Sweets is offline   Reply With Quote