5thWheelForums.com - View Single Post

frostth · 04-11-2008, 04:55 PM

Hello, I have a 2006 32tk3 with the door slide problem.

This is my first time posting a message so hopefully I'll get it right. Anyway, would it be possible to define how big a opening needs to be cut to gain access to the gear spline and broken bolt. I'm just concerned I may not cut a big enough access hole and then have to make it bigger and this would probably make it tough to re-cover and seal properly.

Thanks,

tom frost
2006 32TK3
2008 Ford F450 :D

04-11-2008, 04:55 PM	#12
frostth Junior Member Join Date: Feb 2008 Posts: 5	Door Slide Hydraulics Hello, I have a 2006 32tk3 with the door slide problem. This is my first time posting a message so hopefully I'll get it right. Anyway, would it be possible to define how big a opening needs to be cut to gain access to the gear spline and broken bolt. I'm just concerned I may not cut a big enough access hole and then have to make it bigger and this would probably make it tough to re-cover and seal properly. Thanks, tom frost 2006 32TK3 2008 Ford F450 :D