Mike, The adjustment bolt is horz at floor level in that bracket for the rollers. Useing a socket and extention you access from outside of the pocket door. You do have to remove the floor inside sink area to see it and get on the bolt. A little adj goes a long way here. Too much up and the slide will not tilt back down when moving in and too far down and it drags floor. Tokk a few trys to get it. The ends of the wood at the top of the pocket door had to be trimmed a bit on mine.
Yes Bruce, I remembered your story when mine went south! ha I guess everyone our there with this model will learn one day as well. Wonder if DRV every did? Hummm....
Bill
|