Thread: Battery wiring
View Single Post
Old 04-15-2018, 01:03 AM   #38
Chad Heiser
Junior Member
 
Join Date: Mar 2017
Posts: 20
Sometimes the BMK “brain” needs to be reset in order to start calculating things properly when new stuff is added to the system. Also, every negative cable in your system needs to be on the load side of the BMK shunt. There should be no negative cables for any loads connected to any of the batteries anywhere. If any of your house loads, including your 12 volt power panel, Jack’s, slides, etc are connected directly to the batteries in the door side battery compartment (as DRV does from the factory), then the power they are drawing is not correctly calculated by the BMK.
Chad Heiser is offline   Reply With Quote