5thWheelForums.com - View Single Post

golf_bears · 04-17-2009, 08:07 AM

We have a 2008 MS 36TK3 and I am trying to set up our Direct TV satellite system. I have the satellite signal coming into the RV and have hooked it up to the receiver and directly to the living room TV. Did this to make sure I was receiving a signal and that the receiver was functioning properly.

Now how do I wire up the incoming satellite signal through all the components in the bedroom cabinet to the living room TV. I have the Winegard Select switch with the antenna and cable TV working fine but can’t figure out how to get the satellite signal working.

I know some of you have figured this out and have chatted about it before on this forum. Need your help, please.

Thanks in advance.

04-17-2009, 08:07 AM	#1
golf_bears Senior Member Join Date: May 2007 Location: West Bend, Wisconsin Posts: 397	Direct TV Setup, Help, Help! We have a 2008 MS 36TK3 and I am trying to set up our Direct TV satellite system. I have the satellite signal coming into the RV and have hooked it up to the receiver and directly to the living room TV. Did this to make sure I was receiving a signal and that the receiver was functioning properly. Now how do I wire up the incoming satellite signal through all the components in the bedroom cabinet to the living room TV. I have the Winegard Select switch with the antenna and cable TV working fine but can’t figure out how to get the satellite signal working. I know some of you have figured this out and have chatted about it before on this forum. Need your help, please. Thanks in advance.