View Single Post
Old 02-05-2019, 12:01 AM   #7
dmorse68
Member
 
dmorse68's Avatar
 
Join Date: Nov 2017
Posts: 56
You mentioned all good things. If it were me, I would box the valves, wrap them with heat tape/pads, and then run a new, smaller diameter, flexible slinky style ducting from your furnace into the box. I would look for, or make a “T” or “Y”connector and connect it to your exsisting furnace ducting. The T should have 2 larger openings 4”, and one smaller diameter opening 2”. Use the smaller diameter part of the T and run ducting from it to your valve box. Just a thought. My RV’s furnace had provisions for a 2” ducting and that’s what runs over to my valves and water manifold area to heat them for below freezing times. So first look at your furnace first to see if there is a knockout for an additional ducting. If not then think about the T idea.
dmorse68 is offline   Reply With Quote