|
Hey Rick, Since I pulled all that wet stuff out and put in new and made sure the belly panels were screwed good at frame edges, mine has stayed dry. I have had the pleasure of dropping it down at three spots to fix the shear bolts. Hope it stays dry!!
Tell tale is the dripping from belly. Too much and maybe a water leak...hum...fun fun fun!
Hard foam may be a better deal, would be tricky to get in there without a total drop of the belly and actually securing all the wires, hyd hoses etc that are sprawled all over the place under there. Its not a pretty site. Never mind all the drill screws sticking up all over and a lotto deal it they hit any of the wires or hoses. What the #$%^ were they thinking!
There was actually a spot in behind the propane tank compartment that is sealed that a screw had worn through a hyd hose and it ruptured after 3 yrs. Nice building there. At least the extended warr covered that one.
Bill
|