PDA

View Full Version : water valves


kenscomet
12-05-2015, 01:42 PM
Anybody replace there valves lately
mine are leaking where the two connect one is a plastic valve and the other is a brass one. Our rig is a 2015 RSB3

terry and jo
12-05-2015, 06:48 PM
What valves are you referring to; ones regarding the inside faucets or something in the underbelly?

Terry

kenscomet
12-05-2015, 11:22 PM
What valves are you referring to; ones regarding the inside faucets or something in the underbelly?


Terry
The two in the wet bay, the two behind the water manifold.
The 4 way and the 2 way

Willym
12-20-2015, 10:34 AM
My 'Anderson" valve was leaking recently. It was at the threaded joint behind the valve where the selector valve is tied across to the water heater bypass valve. I had to take off all of the water tubes at the rear, and then take the valve out from the back. I remade the joint using PTFE tape, and now all is fine. It was awkward working behind the valve, but I marked every line with a code so that I wouldn't get them crossed when I reconnected them. If you do this, take care to ensure that the rubber washers inside the female portion of the tubing connectors don't fall out when the tubes are taken off.

Cummins12V98
12-20-2015, 10:48 AM
There is a thread on the Andersen KantLeak valve replacement over on the Thur Forum DRV section.